D-Link DSL-302T Uživatelská příručka stáhnout pdf (Strana 44)

DSL-G604T ADSL Router User’s Guide

Figure 3-10. Setup – Configure Connection 1 for PPPoE

To configure Connection 1 for PPPoE, follow the steps listed below. Some of the settings do not need to be

changed the first time the device is set up, but can be changed later if you choose.

1. Click the

Connection 1

button under

WAN Setup

to view the default

PPPoA Connection Setup

configuration menu.

2. Select PPPoE from the Type: pull-down menu. The menu will blink momentarily

3. Type in a Name: for the connection or use the default name in the space provided (WAN_PPPoA used

in the above example).

4. Under Options, enable NAT and/or Firewall by selecting the corresponding selection box.

5. If you are told to change the VPI or VCI values, type in the values given to you by your service

provider. Many users will be able to use the default settings.

6. Leave the default QoS values if you are unsure or the ISP did not provide this information.

7. Do not change the PCR or SCR values unless you are required to do so. If you are told to change these,

type in the values given to you by your service provider.

8. Type the

Username

and

Password

used to verify the identity of your account. Typically, the Username

is an account number assigned by your ISP and appears in the form account#@serviceprovider.com,

while the Password may have been chosen by the account holder. For most users, the remaining settings

will not need to be changed. See your ISP for further information.

9. Click the Apply button when you have entered all the information. The web browser will briefly go

blank. You are now finished changing setting for the primary WAN connection known as Connection 1.

It is now necessary to save the changes you just made and restart the Router.

10. To save the changes made to Connection 1, click the

Tools

tab and then click on the

System

Commands button. Click on the Save All button to store the configuration settings. Click on Back

button to return to the System Commands menu.

11. Check the WAN connection status. Click the

Status

tab and then the

Connection Status

button. Look

under WAN to view the State of Connection 1, it should read Connected. If the WAN connection state

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 102 103

Komentáře k této Příručce

Žádné komentáře

D-Link DSL-302T Uživatelská příručka Strana 44

Komentáře k této Příručce

Související produkty a manuály pro Sítě D-Link DSL-302T