D-Link dsl-504T Uživatelská příručka stáhnout pdf (Strana 42)

DSL-504T ADSL Router User’s Guide

3. Type in a Name: in the space provided (conn_1_CLIP_8_35 is used in the above example).

4. Under Options, enable NAT and/or Firewall by selecting the appropriate checkbox. This option is not

available for a Bridge connection.

5. Based upon the information your ISP provided, enter the IP Address (e.g. 168.128.1.1), the Subnet

Mask (e.g. 255.255.255.0), ARP Server (e.g. 168.128.1.2) and the Default Gateway (e.g.

168.128.1.1).

6. If you are told to change the VPI or VCI values, type in the values given to you by your service

provider. Many users will be able to use the default settings.

7. Leave the default QoS values if you are unsure or the ISP did not provide this information.

8. Do not change the PCR or SCR values unless you are required to do so. If you are told to change these,

type in the values given to you by your service provider.

9. Click the Apply button when you have entered all the information. The web browser will briefly go

blank. You are now finished changing setting for the primary WAN connection known as Connection 1.

It is now necessary to save the changes you just made and restart the Router.

10. To save the changes made to Connection 1, click the Tools tab and then click on the System

Commands button. Click on the Save All button to store the configuration settings. Click on Back

button to return to the System Commands menu.

11. Check the WAN connection status. Click the Status tab and then the Connection Status button. Look

under WAN to view the State of Connection 1, it should read Connected. If the WAN connection state

does not appear to Connected after a few minutes, go back to the Connection 1 Setup menu, check the

settings and make sure they are correct.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 90 91

Žádné komentáře

D-Link dsl-504T Uživatelská příručka Strana 42