D-Link dsl-504T Uživatelská příručka stáhnout pdf (Strana 43)

DSL-504T ADSL Router User’s Guide

Create a New Connection

An alternative method of changing the connection type used by the Router is to create a new connection.

Creating a new connection will not change the Connection 1 settings, it will make a new set of coneciton

configuration settings. The new set created will be labeled Connection 2, additional connections created will be

likewise labeled Connection 3, Connection 4 and so on. Use the method described here to create up to 8 different

connection configuration sets. At any time you may reconfigure the settings for any previously created

connection by clicking on the menu button for the connection displayed under the WAN Setup heading.

Note

Use the New Connection procedure to create new connection used for accounts that

supports multiple virtual connections. For more information on creating and maintaining

virtual connection, see Multiple Virtual Connections in the following chapter on

Advanced Router Management.

New Connection Example 1 - Create a New PPPoE Connection

The example below describes how to set up a new connection that uses a PPPoE type WAN conneciton. To

create a new connection:

1. Click on the New Connection button.

2. Configure the Router for the Type: of conneciton used and all the remaining settings as discussed in the

preceding section. In this example, the type of connection used for Connection 2 is PPPoE. Notice also

the the VPI and VCI values have been changed.

3. Click the Apply button to cerate the new connection. Notice that a new menu button is created

(Connection 2), this links to the configuration menu for Connection 2 (see example below). If at any

time you want to change, delete, disconnect or connect this WAN connection, click on the Connection 2

button.

Figure 3- 11. Setup a New Connection – Connection 2

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 90 91

Žádné komentáře

D-Link dsl-504T Uživatelská příručka Strana 43