D-Link SharePort Go II Uživatelský manuál stáhnout pdf (Strana 35)

31D-Link DIR-508L User Manual

Section 3 - Conguration

xDSL Broadband (PPPoE)

When you Add a Prole, you must select a Connection Type. Depending on your ISP, you may need to congure the PPPoE

(Point to Point Protocol over Ethernet) settings in order to connect to the Internet. PPPoE is typically used for DSL services.

Request a PPPoE user name and password from your ISP so you can create a xDSL Broadband (PPPoE) Internet Prole.

Note: If you are using a PPPoE connection, you will need to remove or disable any PPPoE client software running on your computers.

Prole Name:

Username:

Password:

Enter a name for this prole.

Enter the Username assigned by your ISP.

Enter the Password assigned by your ISP.

Address Mode:

Service Name:

Reconnect Mode:

Primary

DNS Address:

Secondary

DNS Address:

MTU:

Select Static IP if your ISP assigned you the IP address,

subnet mask, gateway, and DNS Server addresses.

Otherwise, select Dynamic.

Enter the ISP Service Name (optional).

Select either Always-on, On-Demand, or Manual.

Enter the Primary DNS Server Address.

Enter the Secondary DNS Server Address.

Maximum transmission Unit - you may need to change

the MTU for optimal performance with your specic ISP.

1492 is the default MTU.

Click Save to store the settings.

Advanced Settings

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 117 118

Žádné komentáře

D-Link SharePort Go II Uživatelský manuál Strana 35